DICE interface for iPod for selected BMW/Mini Cooper vehiclesInstallation Guide/User ManualO
Lock LockBefore connecting the iPod to the DICE interface, turn the hold switch ON to enable locked mode. For operation in locked mode, please see use
InstallationNote: Installation should only be performed by a qualified professional. Beware of sharp edges to avoid injury and exercise caution when
ATTENTION! There are two 3-pin connectors presented in the vehicle. During installation, make sure that the 3-pin connector from the vehicle does not
8 Remove bottom seat cushion by lifting up and route wiring underneath.9 Route the remainder of the interface cable in the best possible location (ie
If your vehicle has , the purchase of a DICE DSP kit is necessary.To see if your vehicle has DSP look for a bare metal coax cable and a 3-pin connect
The interface automatically charges the battery of the iPod when connected and your vehicle ignition key is in the ACC/ON position.Charging m
16Press or to select Silverline DUO. Pressing this button repeatedly will cycle throughAudio Source Selection:Use the
Source indicatorUse button 1 - 6 to change between DISC numbers.123456- -SC MODEAM FMm+Press the MODE button to access the interface. Press and
INFO1 42 53 6FM AMMODETONE SELECTMENUCDC 2-01 01/02/2008 Press the MODE button to access the interface. Turn the jog dial to change track. Note that
The Silverline DUO integration kit features content browsing. After connecting the iPod, select the desired browsing mode by selecting the appropriate
2Copyrights and TrademarksCopyright 2011 DICE Electronics, LLC. The DICE Electronics logo is a trademark of DICE Electronics, LLC.iPod is a trademark
20SIRIUS browsing function The Silverline DUO integration kit features SIRIUS connectivity. Use seek button or turn the tune dial to browse between su
21The interface is equipped with a 1/8” AUX jack connection adapter to connect an auxiliary device, such as an MP3 player, DVD player or other audio s
22TroubleshootingProblem SolutionNo text display. Make sure DIP switch settings are correctly set for text display (refer to p.9 for dip switch settin
23TroubleshootingProblem SolutionNo audio from iPod source. Reset the iPod. Inspect the dock connector, make sure it clicks to the iPod when connected
Disclaimer24Important disclaimer, please read!Unauthorized reproduction or reverse engineering is strictly prohibited! Intellectual property included
25DICE Electronics strongly recommends that the unit be installed in an easily accessible place! DO NOT PLACE IT BEHIND THE RADIO!Whether the unit is
26Installation notes:Installed by:Install date:Other notes:Illustration:
BMW compatible integration for iPodwww.diceelectronics.comBMW-DUO 2011-3-7
Table of contentsCopyrights and trademarks 2Icon legends 3 Warning and safety 4Product registration 5Integration kit contents 6DIP sw
4Warning and safety!Please read these instructions carefully before proceeding. Failure to follow instructions may result in improper operation or inj
Congratulations on your purchaseThank you for purchasing the DICE integration kit for iPod. Please review our user manual and installation guide befor
Integration kit contents1x Vehicle specific interface unit1x Vehicle specific harness1x USB upgrade cable1x iPod docking cable1x User manual6DICE
7Supported iPod models and firmware version requirements* Special cable (sold separately) require to connect iPad products.For the latest firmware ver
Dip switchesThe dip switches located on the DICE module are used to configure its operating mode. Incorrect dip switch settings may cause the kit to w
Dip switch settings OFF OFF ON OFF9Car configuration switchesSelected modesBusiness CD Radio Navigation RadioDip switch 1OFF OFF ON OFFRecommended fo
Comments to this Manuals